Audi. Saturday , November 04th , 2017 - 15:40:16 PM
In the induction tract, the intake valves close well before the piston reaches bottom dead center. This very short opening time keeps the fresh gas flow comparatively small. When the piston moves back up again after reaching bottom dead center, the compression phase starts later than usual. This allows a high geometric compression ratio of 10.0:1 - the combustion then takes place in a relatively small volume. In comparison to the short compression phase, the expansion phase is extended, which results in a high level of efficiency.
The axle concept of the new RS5 Coupe enables optimal absorption of longitudinal and transverse forces. A revised five-link construction is used on the front axle. At the rear, a five-link suspension replaces the trapezoidal-link suspension used on the previous model. This benefits the sporty driving characteristics and agility. It also improves comfort significantly. With the standard RS sport suspension, the new RS5 Coupe sits 7 millimeters (0.3 in) lower than the base model. Audi Sport offers the RS sport suspension plus with Dynamic Ride Control (DRC) as an alternative. It uses steel springs and three-stage adjustable dampers that are connected to one another via diagonal oil lines and a central valve. When cornering at speed, the valves regulate the oil flow in the shock absorber of the spring-deflected front wheel at the outside of the curve. They increase the support provided and reduce pitch and roll movements. They thus connect the vehicle more closely to the road and improve handling. A new damper generation with integrated control valve ensures much more noticeable spread between the individual modes of the Audi drive select system.
Just like the entire A5 model family, the new Audi RS5 Coupe also benefits from a drastic reduction in weight. It weighs in at 1,655 kilograms (3,648.7 lb) - 60 kilograms (132.3 lb) less than previously. The body of the new RS5 Coupe is among the lightest in the segment. Thanks to geometrical lightweight construction and an intelligent mix of materials, it weighs 15 kilograms (33.1 lb) less than the body of the previous model. The module cross member under the instrument panel, for instance, consists of extruded aluminum profiles and sheets, and the front cross member is an extruded profile.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does tnahid claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.